Rukus Wireless ZoneFlex 7731 Guide de l'utilisateur télécharger pdf (Page 84)

Configuring the Access Point

Configuring Ethernet Ports

Port Type See “Setting Ethernet Port Type” on page 77 for

more detailed information.

■ Trunk port: This port passes all VLAN traffic.

■ Access Port: This port provides network

access.

■ General Port: User-defined VLAN member-

ship.

Packet Forwarding Isolated: Selecting Isolated causes the traffic

from this port to terminate at the Access Point.

Bridge to WAN: The default setting, Bridge to

WAN forwards packets arriving on this port to the

WAN (uplink) port and eventually to their external

destinations using Layer 2 forwarding.

Local Subnet NAT and Route to WAN: This

setting allows routing of packets to their

destinations using Layer 3 network address

translation (NAT).

Bridge to L2TP Tunnel: Uses Layer 2 Tunneling

Protocol to deliver packets encapsulated with an

L2TP header in UDP datagrams.

802.1X Configure the port as an 802.1X authenticator or

supplicant. The following options are available:

■ Disabled: No 802.1X controls are applied to

this port.

■ Authenticator (Port-based): Only one of the

attached MAC hosts must be authorized for

all hosts to be granted access to the network.

■ Authenticator (MAC-based): Each MAC host

is individually authenticated.

■ Supplicant: The port acts as a supplicant to

an upstream authenticator. Configure a port

as Supplicant if the port is a Trunk Port used

to connect the AP to a LAN switch.

See “Working with 802.1X on Wired Ethernet

Ports” on page 78 for more information.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 119 120

Pas de commentaire

Rukus Wireless ZoneFlex 7731 Guide de l'utilisateur Page 84